Spare connector - what is it for?.
1 Attachment(s)
OK - so took out the glove box on my RHD 95 OBD1 (to change over the cruise control module - CC has not worked for over 10 years).
Only to find a spare connector, it is 8-way / 3-pin - looks like it should connect to something that is missing on the metal bracket below it ?. Any guesses as to what it might be for?. |
Re: Spare connector - what is it for?.
so I guess I am the only person with this spare connector?
|
Re: Spare connector - what is it for?.
That looks like the connector for the door lock timer module.
|
Re: Spare connector - what is it for?.
thanks for that - will look into it today, I have a couple of them here, is it part of the security system?.
|
Re: Spare connector - what is it for?.
5 Attachment(s)
OK so it looks like the Timer for Door Lock (what ever that is ?).
The module I have is from USA and uses all 8 pins, the mating part on my car only has 3 wires?. Will try and reverse engineer the PCB from module later on tomorrow. Can someone in NZ or AUS please check under and to the left of the glove box to see a) how many wires comes from their connector and b) what the module p/n is. TIA |
Re: Spare connector - what is it for?.
Yes finally figured out what I actually have -
1x Center console, door lock/unlock switch 1x Under dash door lock timer and I have found the circuit to wire them together ----- all I am still requiring is the switch mating connector.....anyone wanting to get around the U Pull yards and get me one with a short length of OEM wiring - these came only on 95+. |
All times are GMT -6. The time now is 08:11 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122