how do i switch the temp readout to celcius?
 

just wondering........

i am only assuming there is a magic combination of holding/pushing buttons to swap the reading from farenheit to celcius...........?

rob"i wish ONE of my svx came with the owners manual!!"m. :)

There is a connector behind the drivers side kick panel, the one under the fuse panel. The same panel you remove to get to the diagnostic connectors.

I think it's a white connector with one wire, maybe two??? I also don't remember which is which, but I think unplugged will give F, and plugged will give C????

Remove the kick panel on the left side of the car.
Locate a white electrical connector with a SINGLE black wire going into both sides.
Pull apart the white connector.
Put the panel back on, start the car and turn on your climate control. The temperature is now reading in Celsius!
.

White connector with single black wire going into both sides.
Connected: Fahrenheit
Disconnected: Celsius
.

Thanks John, I had a feeling you'd help clarify my cloudy memory :)

thank you kind folks!!

:)

rob"jeez, you'd think subaru would do things easier than THAT!.....oh wait who am i kidding!!"m.

Couple of pictures in this thread: <linky>

One is a bit more useful than the other!

aha !!
thanks letitsnow !
:)

WTF? I started a thread like thi salready asking the same question and everyone was clueless!!!:mad: Oh well I'm just glad to now have an answer !!! :rolleyes: :p

When was that? I never saw it. If you don't get an answer at first, try posting it again by bumping it. Sometimes there are lots of posts going on and we don't get to all of them. I am glad you found out now. Good luck. :)

I forget...prolly a long time cause I've been on Celcius since last summer!!! Anyway it hasn't even been 24 hours and I am SOOOOO happy I can read my temps again!!!:D
Rallyingrob thank you for asking this question!

I am glad you got it fixed the way you want it. Don't be bashful, and if you have a question, ask, and ask again if needed. :)

I would have thought you would now know how to read the temps in celcius by now. :D :D

Actually you can use a switch so that you can switch between celcius and farenheit... not my idea, but I have a small factory installed switch under the temp reading display in my 164L to switch between C and F :) :p
-Pavan.

Re: how do i switch the temp readout to celcius?
 

Hello,

Can we have picture for this, plz?

My english compréhension si very bad

Tx