Installing Starter
I installed a starter on my 96 SVX this weekend. Noticed there are two holes to mount to the transmission. When I removed the old starter all that was in place was a long (5-6") gold bolt. When I went to install I noticed a shorter bolt attached to a ground wire which was mounted to the fire wall. I can only assume that based on its placement and size (2-3") it is meant for the starter.
Is this correct? If so, is the longer bolt meant to go on the upper most mounting hole? Does it even matter? Thanks |
Re: Installing Starter
When I replaced mine, I remember the longer bolt on the top of the starter attaching to the trans. It was also holding a bracket with a bolt attached to a ground wire going to the battery. The bottom bolt is actually a stud that bottoms out on the Trans and has a nut on the end.
|
All times are GMT -6. The time now is 01:00 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122