Anyone have window dimensions
 

I need to make a template of the window that was broken out of my car.
I'd like to insert something until my vehicle can get looked at.
Does anyone have rough dimensions of the lower glass on the door?

Thanks

A window template is easy to make. Get some cardboard, or poster board, hold it inside the window opening and trace with a sharpie. Cut about 1/2 inch outside the mark, then trim to fit. Leave about 2 extra inches to slip down into the door.
You'll notice I never mentioned a tape measure. :D

Thanks for the advice...I had a hard time getting the cardboard down in the channel, but got it close....some duct tape should hold the rest until I get it to a body shop.