Brake lights
Hi - I'm in England and (unsurprisingly) have a UK-spec SVX. On the trailing edge of the bootlid (=trunklid!) there is an inset strip which looks as though it's filling the hole for a third brake light; is this the case? If so, does anyone know where I might get the correct light to put in there? Thanks for any advice!
Best wishes :confused: |
Hi,
The inset strip is actually a transparent red brake light with paint on it. You can remove the paint and install a couple of bulbs or LEDs behind it. Have a read of this: http://www.subaru-svx.net/forum/show...t=14449&page=2 Phil. |
Or better you can always check Ebay, for they are always selling this third brake light. I prefer if you get the Stock brake light for it which will look better than if you do it by yourself.
|
Thanks guys
Information much appreciated! I've not seen one on eBay - but maybe I've not looked hard enough ;) . Failing that I'll go the DIY route. Thanks again, and keep rolling.
Also Phil (but more usually Fil) |
All times are GMT -6. The time now is 09:31 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122