Snap- no pwr to the wheels :( diff?
So driving my 94 L fwd.
was getting on the fwy this morning had gottin up to about 60mph and heard one loud snap/bang. Then it rev'ed up. Pulled over and the engine was still running but wouldn't move in any gears. ... Maybe the diff snaped? I heard no grinding sound tho .... But the car has a ticking sound from the trans area before it stopped and still does after tho so idk if it has something to do with it. Any ideas? It may be time for awd 5speed conversion |
Re: Snap- no pwr to the wheels :( diff?
maybe the flex plate snapped?
|
Re: Snap- no pwr to the wheels :( diff?
^ Sounds like a flex plate to me too.
Replacing the flex plate requires pulling either the trans or the motor (or both). Use a phase 2 flex plate, as they are stronger. (Searching should yield the part number). |
Re: Snap- no pwr to the wheels :( diff?
.
HERE IS THE UPDATED FLEXPLATE AND PART NUMBER 12332AA071 The old style plates were 2.05mm thick The new style plates are 3.25mm thick http://www.subaru-svx.net/forum/atta...8&d=1307156051 . |
Re: Snap- no pwr to the wheels :( diff?
K.I.S.S. check both axles first as if one snaps internally or externally car go nowhere.
|
Re: Snap- no pwr to the wheels :( diff?
Quote:
The "ticking sound from the trans area" sounds like broken flex plate, but maybe a snapped axle would make a similar noise? |
Re: Snap- no pwr to the wheels :( diff?
Quote:
|
Re: Snap- no pwr to the wheels :( diff?
Yeah i am gonna check the axles first. If i put the front end on jacks and put it in gear will a wheel spin if one axle is broken?
.. I popped open the TC bolt access hole i saw the flex plate spinning.. and a few weeks ago i checked all the TC bolts so i know its not them. |
Re: Snap- no pwr to the wheels :( diff?
may move in the air but may not,
|
All times are GMT -6. The time now is 05:07 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122