question about DIY u-joint replacement.
i think my u-joint is bad, i can see grease leaking out and i'm getting the front end shakes. i couldn't see when i was under there but if i remember correctly there is a u-joint in the rear too, is it the same size(part #) as the one up front?
|
You will need a shop press in order top replace them
Tom |
Quote:
|
oh, sorry, it's the main drive shaft(front to back ). i would like to just have it rebuilt but time and money are factors. i do have a shop press do you think 20 ton should be sufice:D? i'm just not sure which parts should be replaced, i know the front is bad, but beyond that i can't find anythreads that have specific parts or #'s for other parts that i should fix while i got it out.
|
All times are GMT -6. The time now is 12:51 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122