Free Labor on Tranny
 

Sounds funny, but I want to try my hand at a 4EAT. I am ASE certified in Automatics. You buy the parts, and rebuild book, I will do the labor and keep the rebuild book. If you live close you can help. This is my first attempt at a 4EAT. I have many others under my belt though.

I don't want to get into a time situation. I want to be able to take my time and get the job done right. I can start the project in June when school gets out.

Why? Because when my tranny goes out, I want to be able to turn it around quickly and effortlessly. We can also keep things posted on the web for the education of the group. Afterall, the better educated you are when you take your car into the shop, the better service you will get.

So if you have a burned out core just sitting around, pass it along to me and you will have a good tranny to sell or to install.

You da man, "teach."

You've only been a part for a short while, but already tapped into the essence of "The Network." I, for one, appreciate your generous offer, as, I'm sure, many here do. I just wish you were closer. :D

For some reason it sounds like fun. I have never built a 4EAT before. It is a good deal and nobody should be scared. I hope someone takes me up on it.

Teach,
I stumbled upon a dealer support site and had it put in the links section. It addresses the 4EAT, mostly the current editions and I find it informative. B. :p

www.endwrench.com

Thanks, I will check it out!

Howdy,
I have a bad 4EAT if you would like to tear into one. I'm not sure what all this one would need but I'm sure you could tell me after you tear it down. Email me at the address below or call. I'm here 7:30-6:00. We can work out how to get this to you.

okay!
 

Sounds like a good summer project.