CV axle? what holds that thing in there
ok, so I can see my cv axle. Long stick boot on each end...... what holds it in place. It looks like its just stuck in there. I have heard that the part near the engine has a roll pin.
What part holds it to the other end just a nut or something? Do I have to take apart ball joint or anything to replace this? |
At the wheel end there is a nut. On the transmission end there is a roll pin.
The nut is under a cap in the center of the brake rotor. |
:ninja: so is it advised to change them both. So that the stiffness will be the same or if the other boots are in tack on the other, just change the one
|
If the boots are good and the joint is not clicking just change the one for now.
|
How do I get that Pin out?
|
3/16" punch
|
and a hammer :D
|
All times are GMT -6. The time now is 08:08 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122