Getting a Production class. Specs needed
The 6 page submital tech specs required that I haven't found yet. Need back up evidence (i.e. shop manuals or whatever to prove).
Wet Curb weight: Rear window slope angle Windshield slope angle Rev limit miethod Block deck height (min) Deck clearance (min Total Combustion chamber volume Valve head dia (max Valve material Connceting rod length (center to center) Connecting rod material: Connceting rod mass: Piston, pin rod and ring(s) mass (min): Crankshaft mass Lift @ lob (max) Lift @ valve (max) Rocker arm ratio Tappet Type Throttle body bore diameter: Spring material dia/thikness Overall spring dia/Width Any help would be greatly appriciated. |
Quote:
Hope this helps. I've got some of the other figures, just not at work;) -Bill |
All times are GMT -6. The time now is 07:30 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122