The Subaru SVX World Network - Drive shaft question

The Subaru SVX World Network (https://www.subaru-svx.net/forum/index.php)

- Technical Q & A (https://www.subaru-svx.net/forum/forumdisplay.php?f=5)

- - Drive shaft question (https://www.subaru-svx.net/forum/showthread.php?t=62543)

fasteract7

02-17-2014 04:31 AM

Drive shaft question

My '92 had a 96 legacy trans/4.44 swap out...does this mean I have a rear driveshaft setup still from my SVX or was a Legacy shaft used ? Will either fit my car now?

Thanks,

Blacky

02-17-2014 06:22 AM

Re: Drive shaft question

The 4.44 1997 Legacy Outback swap on my Claret used the SVX driveshaft. I think it's the only one that will work unless you did a manual swap. I'm not 100% sure though.

1986nate

02-17-2014 07:29 AM

Re: Drive shaft question

Quote:

Originally Posted by Blacky (Post 732115)

The 4.44 1997 Legacy Outback swap on my Claret used the SVX driveshaft. I think it's the only one that will work unless you did a manual swap. I'm not 100% sure though.

Correct. You're not swapping to a different sized transmission so the driveshaft remains the same.

huck369

02-17-2014 08:06 AM

Re: Drive shaft question

Quote:

Originally Posted by fasteract7 (Post 732112)

My '92 had a 96 legacy trans/4.44 swap out...does this mean I have a rear driveshaft setup still from my SVX or was a Legacy shaft used ? Will either fit my car now?

Thanks,

You need an SVX driveshaft....

All times are GMT -6. The time now is 12:58 AM.