Torque specs...
I'm looking for the torque specs for the upper and lower intake manifolds, the throttle body, water x-over, and thermostat housing. Anyone know these or know where I can look them up?
|
I would look in the How-To Documents. I did and found this page with some of them. I hope it helps. :)
|
Thanks a bunch. That page was full of all kinds of useful specs.
|
:rolleyes: It is amazing what you can find in that little section. :) :)
|
Quote:
Bell housing nuts/bolts; 34-40 ft/lb Drive shaft flange; 17-24 ft/lb Rear diff (2) long and (4) short bolts; 94-116 ft/lb Driveshaft carrier bearing bolts; 35-42 ft/lb 15 minute/$15 mod; 39-48 ft/lb 2 rear diff mount nuts; 45-56 ft/lb 6 trans crossmember bolts; 40-61 ft/lb 3 nuts for trans mount; 20-35 ft/lb Spark plugs; 14-22 ft/lb All cam belt sprockets/pulleys; 14-22 ft/lb The 2 bolts on the timing belt adjuster; 17-20 ft/lb |
Got the service manual hosted online at http://serial.cc/ if you want to check it out. You hsould be able to find the specs there easily.
|
All times are GMT -6. The time now is 10:04 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122