My dumb drive shaft disconnect questions
 

Do you typically remove the drive shaft before putting it on a tow dolly or after it is already on?

If before does it need the FWD fuse installed?

Is there enough room under the car to disconnect the drive shaft with out jacking it up first?

Re: My dumb drive shaft disconnect questions
 

As a, stout gentleman, I would rather drive it up onto the tow dolly, as an AWD, and then unbolt the rear end from the driveshaft.
If there is not enough space then I would put a jack under a pinch weld to make more room.
But you, as a young thin buck, should be able top do this without jacking it up further.










stout; a word we fat guys use.:o

Re: My dumb drive shaft disconnect questions
 

Just unbolt it without removing it?

Re: My dumb drive shaft disconnect questions
 

AND move it towards the drivers side and bungee it/duct tape it, to the exhaust pipe.
You can remove it if you like,
just be ready for the ATF to start spilling out.

Re: My dumb drive shaft disconnect questions
 

Thanks. :):)

Re: My dumb drive shaft disconnect questions
 

if you are taking the driveshaft off get a lid off a spray paint can and you can use it to cover the back of the transmission to keep it from spilling out

Re: My dumb drive shaft disconnect questions
 

Ok cool, that makes sense. Gotta be specific on the internet because you never know what some idiot will do based on what you say... ;)

Re: My dumb drive shaft disconnect questions
 

WOW!
You must have some really thick fast drying paint!:rolleyes:

















TEE,HEE,HEE,snort!

Re: My dumb drive shaft disconnect questions
 

What were you saying?????:D

Re: My dumb drive shaft disconnect questions
 

I mostly mean that anyone on the internet can read this, not just those of us who post and stuff.

Re: My dumb drive shaft disconnect questions
 

Wait for it......:rolleyes:

Re: My dumb drive shaft disconnect questions
 

? I'm not getting where you're going.