Brass (double-male) barb connector.. .
Can I use a BRASS double-male barb connector to connect ends of AT fluid lines. Is it compatible with the ATF? I previously hooked two AT lines together (between cooler and campaign filter) with a scrap aluminum tube with lip on one end only .. IT CAME OFF ABOUT 6 MONTHS AGO.. SPILLING ATF EVERYWHERE ON MY WAY HOME FROM WORK! :eek: Ha!
Thanks.. :D |
Re: Brass (double-male) barb connector.. .
You should be able to get a good properly barbed connector in aluminum.
|
Re: Brass (double-male) barb connector.. .
So, BRASS is a problem.. with the ATF? :eek:
|
Re: Brass (double-male) barb connector.. .
Try an avoid a yellow metal like brass in a system (flow circuit) comprised mainly of aluminum. Steel would be a better choice if you can't find aluminum.
|
Re: Brass (double-male) barb connector.. .
OK! Thanks! :cool:
|
All times are GMT -6. The time now is 02:57 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122