Rear diff bushings torn what to replace with?

[svxsubaru1]

This past week when i replaced my 5spd with another one about a week ago (destroyed the original) and I noticed, while jacking up the car that the rear diff bushings that the studs go into to from the rear diff were both completely torn. I was wondering if its possible to replace them with some stiffer stronger ones that wont rip from some abuse, how hard it would be to change, if any one else has had this problem, and could the ripped bushings cause a slight vibration under heavy load from the drive shaft area because of more deflection from the broken bushings? Thanks

[AFBeefcake]

Yes, you can replace them with stiffer aftermarket bushings. There was a group buy on them run by Earthworm. His still have some sets to sell to I think.
http://www.subaru-svx.net/forum/showthread.php?t=29540

I got a set but I have not installed them.

[Earthworm]

I still have a few sets remaining.

[subru92svx]

Hey, I was curious how much for a set?

[TomsSVX]

or you can make ur own... Its not hard

Tom

[Earthworm]

Hey, I was curious how much for a set?
All the details are in the original post of the group buy thread:

http://www.subaru-svx.net/forum/showthread.php?t=29540

(also linked my my siggy)